How many watts does a refrigerator use?
A full-size refrigerator is rated at about 700 running watts and needs about 2,200 watts for a moment when its compressor starts, on the wattage charts of Generac and Westinghouse.
Running watts and starting watts
Two numbers matter for backup power. Running watts are the steady draw. Starting watts, also called surge watts, are the short burst a motor needs to start, often two to three times the running figure, according to Generac. A refrigerator has a compressor, so it has both.
Makers do not agree to the watt. Generac’s help center lists a refrigerator or freezer at 700 running and 2,200 starting watts, and so does Westinghouse’s generator manual. Champion Power Equipment’s chart lists 400 running and 2,200 starting. A Virginia Tech Extension guide on estimating appliance energy use gives a frost-free 16 cubic foot refrigerator a nameplate of 725 watts. For the refrigerator this site uses the higher figures, 700 and 2,200. Adding the starting figure to the running figure, as the makers' method does, the calculator needs 2,900 watts to start one.
It does not run all the time
The same Virginia Tech guide says a refrigerator is plugged in all the time but cycles on and off, and to estimate the hours it runs at full wattage you divide the time it is plugged in by three. That is the rule the calculator uses: 700 watts for a third of the time is about 233 watts on average, or about 5,600 watt-hours in a day.
That is a cautious figure. Anker’s own runtime example uses a refrigerator with a 150 watt average draw, which would be about 3,600 watt-hours a day. Your refrigerator’s yellow EnergyGuide label gives its real yearly use.
What can start one and how long it lasts
Every portable power station and home battery on the calculator can start a refrigerator: the smallest has a 3,000 watt peak output, and the refrigerator needs 2,900 by the makers' method. The question is how long each lasts. These times are for a refrigerator alone, using the cautious 233 watt average and, for the stations, the 0.8 factor BLUETTI prints for conversion loss. The two home batteries are counted at the energy their makers state, without that factor.
| Product | Capacity | About how long |
|---|---|---|
| Anker SOLIX C1000 Gen 2 | 1,024 Wh | 3.5 hours |
| EcoFlow DELTA 3 Plus | 1,024 Wh | 3.5 hours |
| Jackery Explorer 2000 v2 | 2,042 Wh | 7 hours |
| BLUETTI Elite 200 V2 | 2,080 Wh | 7.1 hours |
| Anker SOLIX F3800 Plus | 3,840 Wh | 13.2 hours |
| EcoFlow DELTA Pro 3 | 4,096 Wh | 14 hours |
| Jackery Explorer 5000 Plus | 5,040 Wh | 17.3 hours |
| Enphase IQ Battery 10C | 10 kWh | 42.9 hours |
| Tesla Powerwall 3 | 13.5 kWh | 57.9 hours |
A home standby generator on a gas line is limited by its gas supply, not by a battery: Generac’s spec sheet gives the 14 kW unit’s use at 256 cubic feet of natural gas an hour at full load. Generac’s help center says air-cooled home standby generators are rated by their maximum continuous output instead of a surge rating, and even the smallest one here, rated 14,000 watts, covers 2,900 starting watts many times over.
What to do with the number
If the refrigerator is the only thing you must keep cold, a 1,000 watt-hour station buys a few hours and a 4,000 watt-hour one buys most of a day. Add a freezer, a sump pump or a Wi-Fi router and the load, and the answer, changes. Tick them in the calculator to see the total and what covers it.
Facts read on each maker’s own page on 19 November 2026.